Tips For Installing A Chain Link Fence To Contain Your New Dog

If you have a new dog and want to keep it safe in your backyard using a chain link fence, then you will be pleased to learn that there are many things you can do to make the project move along smoothly. To this end, here are some tips to help you with the fence's installation:

Tip: Always Add Gravel Below Your Below Your Fence Posts for Drainage 

When you dig the post holes for your new chain link fence, make sure that you dig down deep enough to leave room for gravel. You must place gravel in the holes below the fence posts so that storm water has a place to drain. If you do not put gravel under the posts, then they will loosen during winter and your dog will be able to knock down your new fence.

Tip: Always Use a Contractor's Level to Check Posts and Top Rails are Plumb

In order for your fence to look professionally installed and have sufficient structural integrity, it is vital that you use a contractor's level to check each post and top rail that you install. You should level each post and rail as you install them to ensure that the fence is plumb in all areas. A fence that has not been properly leveled can be knocked over by your dog or may fall over during windy storms.

Tip: Use a Come-Along or Fence Stretcher to Tighten the Fence's Chain Link Wire Mesh

One of the hardest things about installing your own chain link fencing is getting the chain link wire mesh tight enough. If the wire mesh is too loose, then it will sag and your fence will not be able to withstand the pressure of your dog rubbing against it. To solve this common problem, you should use either a come-along or fence stretcher to tighten the fence's mesh material.

Tip: dd

Finally, if you are going to be installing a gate in your new chain link fence, then it is important that you leave sufficient space between the posts for both the gate and its hardware. Both the latch and hinges need some space, so make sure you measure them with the gate before you set the terminal posts that will be on either side of the gate. Failure to do this will cause you problems because your gate will be too tight in the space and will not function properly.


Share